Fast diffusion bonding technique for extrusion-based additive manufacturing of high-strength aluminium alloys
Abstract
In aluminium and its alloys, the efficacy of diffusion bonding and extrusion-based additive manufacturing (AM) is greatly limited by the presence of aluminium oxide (Al2O3) on the surfaces to be bonded. In the present work, a novel fast diffusion bonding technique is introduced, in which the surfaces to be bonded are mechanically scraped using an abrasive file immediately before bonding to remove or break the surface Al2O3 layer and reduce surface roughness so that the holding time can be reduced. In the present work, the new fast diffusion bonding technique has been experimentally investigated by bonding similar half-dogbone specimens of aluminium alloys AA7075-T6 and AA6061 to determine the effects of the bonding temperature, bonding pressure and holding time on the strength and properties of the resulting bonded specimens. Bonding curves, showing the pressure required for successful bonding as a function of temperature and holding time, have been constructed. Using the novel technique has been found to increase the maximum strength in tension of bonded specimens of AA7075-T6 and AA6061 by around 12% and 11%, respectively, compared with the conventional method. Metallographic examination has shown that the novel technique aids in eliminating residual microvoids from the bonding interfaces, providing further evidence that the new technique is effective in promoting good-quality bonding. The present work has demonstrated the feasibility of the novel diffusion bonding technique and opens up the possibility for application of the technique in extrusion-based AM to give a hybrid-AM process, allowing high-quality bonding between successively printed layers.
Additional Files
Published
Issue
Section
License
Copyright (c) 2025 Engineering Review
This work is licensed under a Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.
Engineering review uses the Creative Commons Attribution-NonCommercial-NoDerivatives (CC-BY-NC-ND) 4.0 International License, which governs the use, publishing and distribution of articles by authors, publishers and the wider general public.
The authors are allowed to post a digital file of the published article, or the link to the published article (Enginering Review web page) may be made publicly available on websites or repositories, such as the Author’s personal website, preprint servers, university networks or primary employer’s institutional websites, third party institutional or subject-based repositories, and conference websites that feature presentations by the Author(s) based on the published article, under the condition that the article is posted in its unaltered Engineering Review form, exclusively for non-commercial purposes.
The journal Engineering Review’s publishing procedure is performed in accordance with the publishing ethics statements, defined within the Publishing Ethics Resource Kit. The Ethics statement is available in the document Ethics Policies.
