CREATING A PALETTE BOW TIPPER WITH TECHNOLOGY OF DEFORMATION
Abstract
Work shows the entire process of palette bow tipper construction. The process of modeling, preparation and the process of production are described. Parts were prepared for processing on machines by the use of CAD/CAM software following the rules of deformation technology. With the demonstrated procedure, the production process was optimized, and the production process was accelerated and controlled in all production steps. Modeling and simulation were performed by the use of the software SolidWorks. Then the model was separated into sections that were transported in the software ToPs 300, where the optimum use of sheet metal panels was planned and carried out. In this work, the basic rules of modeling and some technological solutions during the execution of the bow tipper palette are demonstrated.Downloads
Published
Issue
Section
License
Engineering review uses the Creative Commons Attribution-NonCommercial-NoDerivatives (CC-BY-NC-ND) 4.0 International License, which governs the use, publishing and distribution of articles by authors, publishers and the wider general public.
The authors are allowed to post a digital file of the published article, or the link to the published article (Enginering Review web page) may be made publicly available on websites or repositories, such as the Author’s personal website, preprint servers, university networks or primary employer’s institutional websites, third party institutional or subject-based repositories, and conference websites that feature presentations by the Author(s) based on the published article, under the condition that the article is posted in its unaltered Engineering Review form, exclusively for non-commercial purposes.
The journal Engineering Review’s publishing procedure is performed in accordance with the publishing ethics statements, defined within the Publishing Ethics Resource Kit. The Ethics statement is available in the document Ethics Policies.
